ORIGINAL RESEARCH |
|
Year : 2021 | Volume
: 12
| Issue : 4 | Page : 189-192 |
|
Effect of the Resin-Based Adhesive Coating on the Shear Punch Strength of Aesthetic Restorative Materials
Najmeh Mohammadi1, Rafat Bagheri2, Lida Vaziri Borazjani1
1 Department of Pediatric Dentistry, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran 2 Department of Dental Material Sciences, Biomaterials Research Center, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran
Correspondence Address:
Rafat Bagheri Department of Dental Materials, Shiraz Dental School, Shiraz University of Medical Sciences, Shiraz 43111 Iran
 Source of Support: None, Conflict of Interest: None  | Check |
DOI: 10.4103/denthyp.denthyp_106_21
|
|
Introduction: This study aimed to investigate the effect of G-Coat Plus (GCP) on the shear punch strength (SPS) of conventional glass ionomer cements (CGICs) and resin composites (RCs). Materials and methods: In this experimental study, four groups of restorative materials (two CGICs (Equia Forte Fil and Fuji Bulk), and two RCs (Aura Bulk fil and Filtek Z250) were used. Twenty specimens were prepared for each material. GCP was applied on the first subgroup (n = 10). The specimens were stored in distilled water at 37°C, and SPS values were measured after 24 hours. Two-way analysis of variance and independent t test were used for data analysis. Results: RCs showed significant higher SPS values compared to the CGICs (P < 0.001). All materials tested showed increased SPS values after applying GCP (P < 0.05). Conclusion: Applying GCP significantly improves the SPS of tooth-colored restorative materials used in this study.
|
|
|
|
[FULL TEXT] [PDF]* |
|
 |
|